Dear Roy, I found out about your 3d printer concept and I liked it very much. So, I bought one, already built. Unfortunately, I encountered an issue while printing, all the time after about 30 minutes of printing. It looks like a heat bed temperature issue, also the led on mosfet stops. When restart, it's ok for the moment. I checked the 2 pin connector of the termistor. Same issue. Strange is because it stops after about 30 minutes all the time. The board is MKS Gen L. Could be only a termistor issue?
Please help me with your expert advise.
Best regards,
Catalin
Dear Roy, I found out about your 3d printer concept and I liked it very much. So, I bought one, already built. Unfortunately, I encountered an issue while printing, all the time after about 30 minutes of printing. It looks like a heat bed temperature issue, also the led on mosfet stops. When restart, it's ok for the moment. I checked the 2 pin connector of the termistor. Same issue. Strange is because it stops after about 30 minutes all the time. The board is MKS Gen L. Could be only a termistor issue?
Please help me with your expert advise.
Best regards,
Catalin